TimeSetl 5pack L298N Board Controller Controller DC DC כפול H-BRIDGE ROBOT STEPPER CONTROCE ומודול מנוע למודול

המאפיינים האחרים

Module name:

dual H bridge motor drive module

Work mode:

H bridge drive (double road)

Main control chip:

ST L298N dual H-bridge driver chip

Logical voltage:

5V

Drive voltage:

5V-35V

Logical current:

0mA-36mA

Driving current:

2A(MAX single bridge)

Storage temperature:

- 20 ℃ to + 135 ℃

Maximum power:

25W

Driver Board Weight:

33g

Dimensions:

43x43x27mm

Notes:

1. General Application:

When your driver is 7V-12V, you can enable the on-board 5V logic supply.

2. When using the on-board 5V power supply, the + 5V power supply in the interface does not input voltage, but it can draw 5V voltage for external use.:

3. Unconventional application of high-voltage drive:

When the driving voltage is higher than 12V, less than or equal to 24V, for example, to drive a motor with rated voltage of 18V,

the jumper cap with 5V output enabled on-board voltage must be pulled out and then outside the 5V output port Connect 5V voltage to L298N internal logic voltage supply.:

There are two ways to turn the system back on:

1. flip the power switch on the back of the computer and wait for the power supply cap to discharge as the relay will reset without power.:

2. after popping the hood and examining for faults, press the button on the relay.There is a red LED on this for power and a green LED to indicate the relay is activated, so you can be pretty sure what state this is in.:

Any time you are trying to hot wire an ATX power supply and you need a toggle function besides the switch in the back, just needs power from pin 9, the relay connected to pin 16 and then of course connections back to ground pin(s).:

Package Includes:

5 X L298N Motor Driver Controller Board Module :